Normal Status Lights - MultiTech RF 820 or 860

Possible Failures

Light
Status
Action to take

Power

Dark

Not powered. Check the power.

Status

Not blinking for extended period ( no heart beat)

Router lockup. Reboot router. Call vendor.

WAN or LAN Link

Dark

No Ethernet signal from connected device.

 

Complete Light Description

LEDs
Description

Power

Lights when power is being supplied to the RouteFinder.

Status

When functioning normally, the LED blinks. The LED is a solid light when the
RouteFinder is booting up, saving the configuration, restarting, or updating the
firmware.

Serial DCD

RF820/RF820-AP only) Lights when Serial port is connected to a remote site.

Serial RXD

RF820/RF820-AP only) Blinks when Serial port is receiving or transmitting data.

LAN10/100M

Lights when a successful connection to the 100BaseT LAN is established. Off when
connected to the 10BaseT.

LAN Link / ACT

Lights when the LAN port has a valid Ethernet connection. Blinks when it is receiving or transmitting data.

WAN 10/100M

Lights when a successful connection to the 100BaseT WAN is established.
Off when connected to the 10BaseT.

WAN Link / ACT

 Lights when the WAN port has a valid Internet connection.
Blinks when it is receiving or transmitting data.